Posts by Basilaris

1) Message boards : RALPH@home bug list : Bug reports for version 5.93 (Message 3669)
Posted 24 Jan 2008 by Basilaris
Post:
2h4o_Boinc_Twist_Angle_Symm_Fold_and_Dock-2h4o_-native__2970_18_0 did not continue at Model 2, Step: 34817, RMSDE 1.187E+004, Energy: -68.98463. Time and Percent complete went on, but nothing happend. After restarting it was the same: it went up to step 34817 and stop. And the graphics went were faulty too.
2) Message boards : RALPH@home bug list : Bug reports for Ralph 5.16 (Message 1690)
Posted 23 May 2006 by Basilaris
Post:
I have the same low step rate, but the workunits finish in the normal time after perhaps 4000 steps or so.

Graphics are ok in my workunits.






©2024 University of Washington
http://www.bakerlab.org