1)
Message boards :
RALPH@home bug list :
Bug reports for 5.66-5.68
(Message 3200)
Posted 14 Jun 2007 by Conrad Poohs Post: This WU failed after 4 seconds and apparently tried to access the internet (according to ZoneAlarm). |
2)
Message boards :
RALPH@home bug list :
Bug reports for 5.66-5.68
(Message 3197)
Posted 13 Jun 2007 by Conrad Poohs Post: This WU failed. I had a Blue Screen of Death at this point. Cannot determine if the WU caused the computer to crash or the computer crashing caused the WU to fail. |
3)
Message boards :
RALPH@home bug list :
Bug reports for Ralph 5.52-5.54
(Message 2878)
Posted 17 Mar 2007 by Conrad Poohs Post: This WU ran for two hours, my setting is four, and produced 30 nstructs 1 decoys. |
4)
Message boards :
RALPH@home bug list :
Bug Reports for 5.44
(Message 2692)
Posted 21 Jan 2007 by Conrad Poohs Post: I hoped that the graphics were fixed in 5.44 but when I left the screensaver on and came back to it I couldnt exit screensaver mode without cancelling This WU. |
5)
Message boards :
RALPH@home bug list :
Bug reports for Ralph 5.33 and 5.34
(Message 2433)
Posted 26 Oct 2006 by Conrad Poohs Post: Feet1st. Thanks very much for the Info. I had got my head around most of that, it was just that it was the first time I had seen the time to go increase to quite such an extent (out to over 6 hours for a WU that estimated run time a about 3 hours). It also seems to me that the WU didn't checkpoint for some 3 hours but it was the large increase in run time that threw me. Thanks again. Regards, Andy G. |
6)
Message boards :
RALPH@home bug list :
Bug reports for Ralph 5.33 and 5.34
(Message 2430)
Posted 25 Oct 2006 by Conrad Poohs Post: Above WU finally finished all of a sudden, having reduced run time back down to 2h 53m from over 6h (it actually suddenly changed to 90-something % complete and reduced time to go to a couple of minutes and run time to 2h 52m then completed). As it actually clocked up considerably more runtime than it says I feel slightly cheated as I assume credits will be granted according to reported run time. Regards, Andy G. |
7)
Message boards :
RALPH@home bug list :
Bug reports for Ralph 5.33 and 5.34
(Message 2429)
Posted 25 Oct 2006 by Conrad Poohs Post: Oops, forgot to say that WU is 263878. Regards, Andy G. |
8)
Message boards :
RALPH@home bug list :
Bug reports for Ralph 5.33 and 5.34
(Message 2428)
Posted 25 Oct 2006 by Conrad Poohs Post: I have a WU which seems to be 'stuck' ie. the run time and the time to go are increasing at about 1 sec per sec but % done is remaining at 39.901. I have tried stopping and restarting BOINC Client (as this has worked in similar situations before) to no avail. This WU is hogging my BOIC processing as my PC (DELL 4600 Intel P4 3.00Ghz WinXPSP2) is now overcommitted. Any answers please as I am only willing to give this WU another couple of hours unless it moves on. Regards, Andy G |
9)
Message boards :
RALPH@home bug list :
Bug reports for Ralph 5.30 and 5.31 and 5.32
(Message 2386)
Posted 11 Oct 2006 by Conrad Poohs Post: I got two WUs which started while Monitor was switched off. One had an error regarding screensaver, it then stopped processing but did not exit (though it said it did) until end of time slot, it then fell over:- 2006-10-11 02:03:43 [ralph@home] rosetta_beta not responding to screensaver, exiting 2006-10-11 05:47:10 [ralph@home] Unrecoverable error for result IDL_RLX_NT_t364_CASP7_hom001_1_1342_3_0 ( - exit code -1 (0xffffffff)) The second WU ran alongside and seems fine so far, having completed one two hour time slot, another 3.5 hours to run, fingers crossed. |
©2023 University of Washington
http://www.bakerlab.org